Ctl Lx-Lite VoiceSupport Manuel d'utilisateur télécharger pdf (Page 15)

Installing the Hardware

VoiceSupport LX System Guide 2-1

Chapter 2 Installation and Setup

Chapter 2: Installation and Setup

Installing the Hardware

Tools

Required

Phillips screwdriver

Note VoiceSupport systems will have the required software preloaded at the

factory. The software is provided in the event of a system failure requiring

the software to be reloaded.

Mounting the

VoiceSupport

Unit

The VoiceSupport unit is suitable for mounting in a 19 inch rack or can be placed on

a flat surface. There is also a wall mount bracket included with the unit to allow

mounting on a solid flat surface.

Connecting

VoiceSupport

to a LAN

The VoiceSupport unit contains a LAN connector on the rear panel. This is an RJ-45

connector providing a Gbit Ethernet connection to a local network. Connect an

Ethernet cable from the LAN port on the rear of the VoiceSupport LX to the network.

Connecting

AC Power

The VoiceSupport Power Supply is auto voltage sensing and will accommodate

either 110 or 220 Vac, 60 Hz, single phase power.

1) Connect an AC line cord from the AC receptacle on the rear of the unit to a

grounded 110VAC receptacle. (See Figure 1-3.)

2) Press the Power switch on the rear panel of the unit. Make sure that the green

Power indicator on the front panel is lit. (See Figure 1-2)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 197 198

Pas de commentaire

Ctl Lx-Lite VoiceSupport Manuel d'utilisateur Page 15